Canon R5 Mark II Firmware 1.0.1 Available

R5 Mark II: https://www.usa.canon.com/support/p/eos-r5-mark-ii 

I find it interesting that the size of the firmware for the original R5 is 56 MB, for the Mark II it is 264 MB, quite a difference.

Canon also released new firmware versions for several other cameras, such as R3, R5, R6, R6II, R7, R8, R10

Axel Hildebrandt wrote: ... Canon also released new firmware versions for several other cameras, such as R3, R5, R6, R6II, R7, R8, R10

There is no f/w update for R7!

Firmware Updates Available
EOS R3 Firmware Update, Version 1.8.0
EOS R5 Mark II Firmware Update, Version 1.0.1
EOS R5 Firmware Update, Version 2.1.0
EOS R6 Mark II Firmware Update, Version 1.5.0
EOS R6 Firmware Update, Version 1.9.0
EOS R8 Firmware Update, Version 1.4.0
EOS R10 Firmware Update, Version 1.6.0
EOS R50 Firmware Update, Version 1.3.0
EOS R100 Firmware Update, Version 1.1.0

I just double-checked and the new R7 firmware was released here yesterday, it's at 1.6.0

https://www.usa.canon.com/support/p/eos-r7#idReference%3Dsoftware-drivers

Oops! You're right about EOS R7 Firmware Update, Version 1.6.0

Firmware Version 1.6.0 incorporates the following enhancements and fixes:
1. Enables functions to be used without limitation in conjunction with the new Battery Pack LP-E6P.
This makes it possible to shoot at the same continuous shooting speed as when using LP-E6NH.
In-camera charging of LP-E6P is also supported.
2. Adds the ability to select [WPA2] and [WPA3] as a secured protocol.
3. Adds support for the Software Development Assistance Kit (EDSDK/CCAPI).
4. The following issues have been fixed.
　4-1. Fixes an issue, in which when SPEEDLITE EL-5, EL-10 is attached, the "Accessory unavailable status" message may be displayed when restarting after the camera has gone into Auto Power Off. (Only occurs with firmware Ver.1.5.0)
　4-2. Fixes an issue, in which when performing shooting in high-speed continuous shooting + mode with the [Highlight Tone Priority] option set to [ON], focus may not be achieved when certain ISO speed settings are used.