Tripod Head Compatibility:

Your tripod head must have an Arca-Swiss style quick-release clamp (e.g. Arca-Swiss, Kirk, Really Right Stuff, Markins, Acratech, Foba, Studioball) in order to use with Wimberley plates.

Lens Compatibility:

Look for your lens on our compatibility chart to find the appropriate plate for your lens. If your lens is not on the list, please use the plate pictures and dimensions listed to guide your selection.

Note: Your lens must have a rotation collar and a mounting foot with a 1/4" mounting hole (1/4-20 threads). You can convert a 3/8" hole to a 1/4" hole by using a Brass Reducer Bushing which you can obtain through us for $3.

Safety Stop Compatibility:

Note to Arca-Swiss Z1 users: The safety-stop security feature of Wimberley plates does not work when used with the Arca-Swiss "double-decker" clamp (see Figure 3 below). Wimberley recommends replacing the double-decker clamp with the C-10AS modified clamp, or ordering the Z1 ball head without a quick-release clamp and installing our C-10AS, if this safety feature is important to you. Please contact us for details.

Wimberley Clamp:

Wimberley's clamps have channels of a specific depth that go almost to the center. These channels allow a full range of forward and back motion but will not let the plate slip out if the clamp becomes a little loose.

Old-Style Clamp:

Fore-aft movement is limited. Without a center channel cut-out, the plate will only move until the stop screw hits the side of the clamp. Wimberley safety stop screws will not work at all if the clamp is over 1.95 inches long.

Arca-Swiss Double-Decker Clamp:

The extra cut-out leaves nothing to stop the plate from coming out.

Dual Safety Stops:

Safety stops at the front and back of Wimberley plates keep your expensive lens from accidentally slipping out of the quick-releaseclamp. If you wish to use only one or neither of these stops, simply remove them with the hex key provided.

Note to Arca-Swiss Z1 users: The safety-stop security feature of Wimberley plates does not work when used with the Arca-Swiss "double-decker" clamp. (See Figure 3 at the bottom left of this page)

Flash Bracket Versatility:

Wimberley plates are designed to accept RRS & Kirk flash brackets as well as their own quick-release flash brackets.

Double-Dovetail Cross-Section:

Our unique double-dovetail design allows you to attach Wimberley quick-release flash brackets to the upper or lower surface of the plate.

Wimberley flash brackets attach to the top of the plate...	...or to the bottom.

Anti-twist Nubs:

The P-10, P-20, and P-30 plates have anti-twist nubs at the back of the plate. These help to keep the plate from twisting if it is mounted with only one fastener. The unique dual-nub design (as opposed to a single continuous flange) provides better performance when butted against a curved surface. The P-40 and P-50 plates do not have anti-twist nubs because they should be attached with more than one screw.